Edge coating can be achieved by screen-printing or digital printing process. The edge coating is widely used for overlapped units and in some cases also structural glazing. There are some situations when edge coating is used fro Walk-on gla...
We are able to offer sandblasting in almost any design type.
Sandblasted glass is produced by spraying sand at high velocities over the surface of the glass. This gives the glass a translucent surface, which is usually rougher than that obtained by etching. During sandblasting, areas that are to remain transparent are masked for protection. The depth and degree of the translucency of the sand-blasted finishing vary with the force and type of sand used.
The sandblasting technique is used to obscure visibility through glass, but the glass continues to still transmit light as it is diffused through the surface. Patterns and designs can be created using a mask which resists the abrasive force of the grit from the sandblaster. The mask can be hand cut or computer cut depending on the complexity of the design.
Recommended for logos, house numbers or any other decors in the commercial or domestic sectors.
Thicknesses: 3-8 mm
Minimum sizes: 100 x 250 mm
Maximum sizes: 1500 x 2400 mm